G&W Fret Slot Depth Gauge

G&W Fret Slot Depth Gauge fret slot depth I cut the slots straight on a table saw before cutting the radius I usually cut them about deep, then the radius reduces the depth on fret slot width Fret slots are deeper than fret tangs? Not a big deal But if want to fill those areas, get a small piece of rosewood (or something equally

fret slot width Fretwire has a toothed piece called the tang which will stick into a slot in the fretboard The tang is typically in width, so ideally you

fret slot saw Fret slotting saw giving a kerf of inches, for cutting fret slots in a guitar fingerboard Complete with a perspex guide to control the depth Stewmac, Fret Slot Depth Gauge Don't wait until after you've installed a fret to discover the slot wasn't quite deep enough! Dan Erlewine developed this